Description Knee Replacement Surgery
The length and complexity of a total knee replacement operation depend in part on whether both joints are replaced during the operation or only one. Such disorders as osteoarthritis usually affect both joints, and some patients would rather not undergo surgery twice. Replacement of both joints is known as bilateral TKR, or bilateral arthroplasty. Bilateral joint replacement seems to work best for patients whose joints are equally weak or damaged. Otherwise most surgeons recommend operating on the more painful joint first so that the patient will have one strong leg to help him or her through the recovery period following surgery on the second knee. The disadvantages of bilateral joint replacement include a longer period of time under anesthesia; a longer hospital stay and recovery period at home; and a greater risk of severe blood loss and other complications during surgery.
If the operation is for on only one, it will take two to four hours. The patient may be given a choice of general, spinal, or epidural anesthesia. An epidural anesthetic, which is injected into the space around the spinal cord to block sensation in the lower body, causes less blood loss and also lowers the risk of blood clots or breathing problems after surgery. After the patient is anesthetized, the surgeon will make an incision in the skin over the knee and cut through the joint capsule. He or she must be careful in working around the tendons and ligaments inside the joint. Knee replacement is a more complicated operation than hip replacement because the hip joint does not depend as much on ligaments for stability. The next step is cutting away the damaged cartilage and bone at the ends of the femur and tibia. The surgeon reshapes the end of the femur to receive the femoral component, or shell, which is usually made of metal and attached with bone cement. For answers about Health Insurance in Texas Selected Benefits has your answer.
After the femoral part of the prosthesis has been attached, the surgeon inserts a metal component into the upper end of the tibia. This part is sometimes pressed rather than cemented in place. If it is a cementless prosthesis, the metal will be coated or textured so that new bone will grow around the prosthesis and hold it in place. A plastic plate called a spacer is then attached to the metal component in the tibia. The plastic allows the femur and tibia to move smoothly against each other.
Lastly, another plastic component is glued to the rear of the patella, or kneecap. This second piece of plastic prevents friction between the kneecap and the other parts of the prosthesis. After all the parts of the prosthesis have been implanted, the surgeon will check them for proper positioning, make certain that the tendons and ligaments have not been damaged, wash out the incision with sterile saline solution, and close the incision.